0
First you need access to it if its in the car. Remove the air cleaner, starter, and right drive axle.
Use a chisel or a punch to turn it sideways. If it has a hole in it, you can pry it out using the hole.
To install find a socket that just fits inside the freeze plug. Use red lock tight on the hole in the block. Drive in the plug with a hammer as squarely as possible.
What else can I help you with?
What type of transmission fluid do you use for a 1987 Plymouth reliant?
Mopar ATF+3 or Mopar ATF+4
How do you change the front shocks on a 1987 Plymouth reliant?
To change the front shocks on a 1987 Plymouth Reliant, begin by safely lifting the vehicle and securing it on jack stands. Remove the front wheels, then unbolt the top and bottom shock mounts using the appropriate socket size. Replace the old shocks with new ones, ensuring they are properly aligned, and then reattach the bolts. Finally, re-install the wheels, lower the vehicle, and perform a test drive to ensure everything is functioning correctly.
Where is the speed sensor on your 1987 Plymouth reliant?
On a 1987 Plymouth Reliant, the speed sensor is typically located on the transmission. It's usually mounted on the side of the transmission case, often near the output shaft. In some configurations, it may also be integrated with the vehicle's speedometer cable. If you're having difficulty locating it, consulting the vehicle's service manual can provide specific details and diagrams.
Where is the computer on 1987 Plymouth reliant k?
The computer, or Engine Control Module (ECM), on a 1987 Plymouth Reliant K is typically located in the passenger compartment, often under the dashboard or near the glove box area. It may also be found mounted to the firewall. This module is responsible for managing various engine functions and diagnostics. If you're looking for it, be sure to check the vehicle's service manual for specific details on its exact location.
Timing diagram for 1987 2.2 Plymouth reliant?
To set the timing you unplug the temp. sensor in the thermostat housing and set the timing to 12 degrees before T.C. with the automatic trans.
How do you change fuses on 1987 Plymouth reliant?
To change the fuses on a 1987 Plymouth Reliant, first locate the fuse box, which is typically found under the dashboard on the driver's side. Remove the cover to access the fuses, then identify the blown fuse by checking for a broken wire or discoloration. Carefully pull out the faulty fuse using a fuse puller or pliers, and replace it with a new fuse of the same amperage. Finally, reattach the fuse box cover and test the electrical components to ensure they are functioning properly.
How much does a 1987 Plymouth Voyager weigh?
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.
When was Plymouth Sundance created?
Plymouth Sundance was created in 1987.
How much does a Plymouth Voyager weigh?
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.
Did 1987 Plymouth have air bags?
no
Where is the fuel filter for a 1987 Plymouth horizon?
where is the fuel filter on a 1987 plymouyh horizon?
What freon do you use on a 1987 Plymouth wagon?
R-12 was used in 1987 vehicles.
