its acyually easy im 14 and i know how get a drill and some screws some wireing and some nice speakers take the door out make a mold for it set it in there drill the screws in and get the wiring in
Commodore front and rear doors fit 6" speakers
Holden VT Commodore was created in 1997.
turn signal located on VT commodore
how much to get brake pads and rotors replaced on a holden vt commodore
1.5mm
To replace a rear wheel bearing of a VT Commodore, remove the hub from the car and press it in and out. The bearing has an inner and outer seal. The inner seal has a magnet for the abs sensor. Make sure to install the new bearing before the abs will pick up a speed fault.
Passenger side kick panel
Replacing a head gasket on a VT Commodore instructions can be found in a manual. Manuals can be bought at most auto parts retailers or in book stores.
The flasher unit relay location on a 1997 VT Commodore is under the steering column. The door has to be opened to reach the relay.
To fix the door handle of a VT Commodore, remove the hardware from the door and loosen the knob. Remove the turn post and tighten all mechanical parts.
I found this whilst looking for an answer myself ;-) (don't know if this site allows links so just ad http before the : ) ://forums.justcommodores.com.au/vt-vx-holden-commodore-1997-2002/83178-where-vt-sump-plug.html
Undo the transmission pan.