How do you install a stop light switch on a 1972 cougar
location of fuse box in 1972 mercury cougar
start by loosening the set screw on the knob. it is very small, so dont loose it. then take of the retaining nut and you can take the switch out from the back of the inst. cluster.
The fuse box on a 1972 Mercury Cougar XR7 is located in the lower left of the dash next to the brake pedal. To access the fuse box, open the driver's door and remove the clips holding the cover in place.
Driver side under the dash far left side.
BAD IGN SWITCH
To replace the ignition switch on a 1972 Duster, first disconnect the battery to ensure safety. Remove the steering column cover and locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness from the old switch, remove any screws or bolts securing it, and take out the switch. Install the new switch by reversing the process, ensuring all connections are secure before replacing the steering column cover and reconnecting the battery.
According to one of Fords websites : For the 1972 Mercury Cougar , 5.8 liter / 351 cubic inch V8 engine : ( Motorcraft FL-1-A engine oil filter )
1972
Yes you could but it has a neutral safety switch for a reason.
Check the high-low beam switch on the floor. The connections behind the switch get corroded/rusty.
On top of lower portion of steering column.
after electrcally disconnecting the switch there should be a small button on the bottom of the switch body that will release the switch shaft. then just pull it out and do the inverse to put the new one in.