Starter = Removal & Installation = 1. Disconnect the negative battery cable. 2. Raise and safely support the vehicle. 3. Remove the starter terminal cover. 4. Remove the terminal nut and separate the battery starter cable from the starter motor. 5. Disconnect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid. Ø To disconnect the hard-shell connector from the solenoid (S) terminal, grasp the plastic shell and pull off; do not pull on the wire. Pull straight off to prevent damage to the connector and (S) terminal. 6. Remove the starter motor retaining bolts. 7. Remove the starter motor from the vehicle. To Install: 8. Place the starter motor in position and install the starter motor retaining bolts. Tighten the bolts to 15-20 ft. lbs. (20-27 Nm). 9. Install the battery starter cable and a terminal nut to the starter motor. Tighten the terminal nuts to 79 inch lbs. (9 Nm). 10. Connect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid. 11. Install the starter solenoid safety cap. If equipped. 12. Lower the vehicle. 13. Connect the negative battery cable. 14. Start the engine several times to check starter motor operation.
8.8
5.5"
Oil
from 89 through 1996 the rims have the same bolt circle and from 1997-2003 and 2004-2011. However, if the tires are larger than stock on the 4x4 you will probly have clearance issues on the 2x4.
158 oz
5 ON 5.5
yes, it will fit
The headlight adjustment for the 1989 F150 2WD is below the actual headlight. You will need to pull the tab at the top of the headlight up to release the headlight and then you can adjust the angle of the light with the long bolt below the housing.
watch video on youtube.
Is a 2wd Dakota truck flat towable
Should be on the side or rear of the oil pan
ford speed sensor are usually in the differential housing.