0
What else can I help you with?
How do you replace an idler pulley on a 1998 Mercury Villager?
To replace the idler pulley on a 1998 Mercury Villager, first, disconnect the negative battery terminal to ensure safety. Next, remove the serpentine belt by loosening the tensioner pulley with a wrench, then slide the belt off the idler pulley. Unbolt the old idler pulley using a socket wrench, and install the new pulley in its place. Finally, reattach the serpentine belt and reconnect the battery terminal.
How do you change an idler arm on a 1998 GMC Safari Van?
To change the idler arm on a 1998 GMC Safari Van, first, ensure the vehicle is securely lifted and supported on jack stands. Remove the nut and bolt securing the idler arm to the frame and the pitman arm. Replace the old idler arm with a new one, tightening the fasteners to the manufacturer's specifications. Finally, recheck the alignment, as replacing the idler arm can affect steering geometry.
How do you change a idler arm on a 1998 Chevy s10?
How much torque do I use to tighten the idler arm
How do you replace idler pulley on 1998 Oldsmobile intrigue?
the bolt comes out with the oposite lefty tighty and righty loossey. over righty tighty and lefty loosey
Where is idler pulley on 1998 Ford Escort 1.9 engine?
The idler pulley is between the alternator and the A/C compressor.
How do i replace heater filter on 1998 suburban?
Are you sure it has one? If so, just purchase a Purolator Cabin Filter. It comes with detailed instructions on how to replace it.
Where would you find instructions on how to replace a turn signal switch on a 1998 Chevy S10?
you can find it in your truck's manual. you should get directions inside on how to replace it.
How do you change an idler arm on a 1998 Chevy blazer?
Remove the nut holding the idler arm to the center link. Separate the joint with a "pickle fork". Remove the two bolts and nuts from the frame end of the idler arm. Remove idler arm.
How many idler arms and pitman arms do a 1998 Chevy Tahoe have?
1
How do I replace a stereo in a 1998 Dodge Dakota?
go to walmart and pickup the aftermarket stereo installation kit for your vehicle. instructions included.
Remove and replace the shifter shaft sportster 1998 harley Davidson?
good instructions in the manual. I just removed mine to have it welded.
How do you change the WATER DRIVING belt on a 6 cylinder 1998 Mercury Mystique?
Not trying to be a smart a&^ but if you do not know that it is called a "Water Pump", you probably don't need to try and replace the belt. But basically you loosen whatever the belt is driving in addition to the Water Pump. Alternator, A/C compressor, Or P/S Pump. This will loosen the belt and allow you to replace it. Tighten the device you loosened until you have about 1/4" deflection at mid-point of the new belt. If you have one a serpentine belt with an idler pulley, then it is under tension by means of a spring loaded idler. Remove tension from the idler pulley and then remove the belt. Reverse to replace the belt. Tension is automatically adjusted. Check the condition of the idler once the belt is removed. Noisy, or rough turning idler should be replaced. Pay close attention the the routing of the belt. Take a digital photo if necessary.
