The starter is on the bottom passenger side of motor. disconnect the battery first. then disconnect the wires attached to the top of the starter. then remove the 2 bolts going thru the starter to remove.make sure you keep track of any shims and put them back in . install in reverse order
Where is the control module located on the 1983 Chevy blazer
NO!
The gross weight for a Chevy Blazer 2 door 4x4 is 5300 pounds. The Chevy Blazer was produced from 1983 to 2005.
The wiring diagram for a 1983 Chevy Blazer can be found in the service manual. It contains a detailed layout of where each wire goes and its function.
A 1983 Chevy Blazer transmission will hold 12 quarts of transmission fluid. The manufacturer recommends using a. SEA certified transmission fluid.
Any 1983 - 1993 S10, and 1983 - 1994 Blazer, Jimmy, or Bravada.
I found the answer on AutoZone.com There was a section on repair info and then go to Heater Core GM Blazer/Jimmy/Typhoon/Bravada 1983-1993 Repair Guide. It has a detailed guide and pictures. Good Luck!
Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.
*sighs* found it... behind the front passenger side tire.
Mazer Blazer - 1983 VG was released on: USA: 1983
If things are worn alittle It helps to get it out of 4x4
Back then the headlight circuit was protected by a circuit breaker that was built into the headlight switch.