0
How do you install the trigger group in Browning Invector plus BPS?
Wiki User
∙ 14y ago
Ask a gunsmith for help
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you adjust trigger on a Winchester 94?
If you have a newer Winchester with a rebounding hammer, a great way to improve your gun is to replace the entire trigger group from an older rifle's trigger group with the traditional half-cock safety. The older trigger groups will fit between any model 94 rifle. I have done it numerous times, the only slight modification you may have to make is when you take a trigger group from an older rifle where it has the guide rail, you can carefully grind off the guide rail from the trigger group and then it will fit fine. The grinded off guide rail will not show once the new trigger group is installed. As for just trying to adjust your trigger, this is very tough to do without screwing the entire thing up. The older trigger group from older rifles is a much better system and has a much better pull.
4 Major component assemblies of the M500 shotgun?
Stock group, receiver group, barrel group, and trigger group.
What is an anaphylatoxin?
An anaphylatoxin is any of a group of toxins which trigger anaphylaxis.
Will browning fix new bar rifle if won't group shots right?
Talk to Browning Customer service (check their website) Browning has an excellent reputation for standing behind what they make.
How does one remove the trigger assembly on a JC Higgins Model 29 patent 2552429 with no apparent trigger pins or screws to remove?
The wooden forend on that gun extends back along both sides of the receiver. There is a big honking screw that goes through the wood and the receiver from left to right. Remove that screw and you will be able to remove the trigger group downward and rearward. Please be careful not to lose the disconnector from the right side of the trigger group. Do not dry fire the trigger group. In fact, my advice is not to attempt to disassemble the trigger group unless you are very familiar with that action. It is easy to take apart, but difficult to reassemble. sales@countrygunsmith.net
How do you field strip a Remington model 742 30-06?
Loosen the forend screw and remove the forearm.Clean & lightly oil the operating slide, spring & gas piston.Push out the two trigger-guard pins and pull the trigger group out of the receiver.Clean & oil the trigger group & internal parts of the receiver.(DO NOT snap the hammer with the trigger group out of the gun.)Further stripping (removing bolt, etc.) is not possible on this rifle without gunsmith tools & knowledge.
How to replace trigger group in Winchester 1500?
Best left to a trained gunsmith
How do you disassemble a Remington Model 7600?
Disassemble to do what? To remove the trigger group you need to push out the two pins in the receiver to remove the trigger group. To remove the bolt you need to take the barrel off which requires an armorers barrel wrench.
Major Component Groups of the M16 Rifle?
Upper Receiver: Bolt Carrier Group: Gas System Lower receiver: Trigger Group
Will a Remington model 58 trigger group fit an 1100?
yes it will all you have to do is to take it apart
What is the cheapest Mil-Spec AR15 trigger group assembly?
DPMS sell a complete kit for $68.
Can you put an older Ithaca Model 37 12ga trigger group with the ability to slamfire into a modern Ithaca?
No
