answersLogoWhite

0

the throw out bearing is located in between the engine and transmission so you must remove the transmission and it will be on a fork holding the the throw out bearing on the transmission but remember that when you take out a tranny you must take out the the oil from it

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

When did GWA Mazda Tennis Classic end?

GWA Mazda Tennis Classic ended in 1985.


Will a 1985 Mazda rx7 transmission fit a 1988 Mazda rx7?

Depends, which engine is in the 85, 13b or 12a?


How many miles to gallon does a 1985 Mazda Rx7 get?

about 25 mpg


What is the spark plug gap for a 1985 B2000 Mazda 2.0 liter engine?

The spark plug gap for a 1985 B2000 Mazda with a 2.0 liter engine is .8 mm. This is equal to .031 inches.


How do you replace a wheel berring on an 1985 Oldsmobile regency 98?

how do you replace a wheel bearing on an 1985 oldsmobile regency 98


How do you change the release bearing on a 1985 Toyota tercel?

You need to pull the halfshafts, to get to the trans axle. Then pull the transaxle out from under the car and the release bearing is on the transaxle shaft, you'll need to get a bearing puller to get the bearing loose from it's housing.


What is the valve clearance of a 1983 Mazda B2200 diesel engine?

the valve lash for a 1985 Mazda 2.2 diesel is .012 in under cold conditions


How to replace 1985 Mazda rx7 starter?

To replace the starter on a 1985 Mazda RX-7, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is typically found on the lower side of the engine near the transmission. Remove the electrical connections and the mounting bolts securing the starter in place. After taking out the old starter, install the new one by reversing the steps, ensuring all connections are tight and secure before reconnecting the battery.


How do you install a stereo in a 1985 Honda Accord?

To install a stereo in a 1985 Honda Accord, make wire to wire connections using either a solder iron and electrical tape.


What cars use a 4x110 mm bolt pattern?

Mazda RX7 1979-1985


How do you replace water pump Mazda 323 1985?

To replace the water pump on a 1985 Mazda 323, first, disconnect the negative battery terminal and drain the coolant. Remove the serpentine belt, then take off the timing belt cover to access the water pump. Unbolt the old water pump, clean the mounting surface, and install the new pump with a new gasket, ensuring proper alignment. Finally, reassemble all components, refill the coolant, and check for leaks.


Where is turn signal and hazard flasher on 1985 Mazda rx7?

to the left, right, or under the steering wheel.