You have to loosen the screws on the mirrors then just slide it on
the inner door panel has to come off and the whole window unbolts and it will come out.
A vent window on a Blazer? Wow, it must be an old one. Need to know what year you have.
should be the same door and yes you should be able to eliminate the vent window as it just bolts in the door, I didn't think a 68 had a vent window.
take inside door panel off and the vent window is bolted inside the door as it also I believe acts as the front window channel.
The 2008 Ford F150 doesn't have a vent window. They do come with a Vent visor so that you can roll your window down a little bit without being in the elements, a replacement will cost you about $50.
There should not be a vent penetration that close to a valley.
e-heko.co
How do you replace vent windowin a 2005 chevy malibu?
1998 Chevrolet Blazer did not have vent windows.
In plumbing the roof vent should be a min of 4" to prevent hoarfrost
Your vent covers should be very easy to install it is a simple diy job. You can find an instructional video at www.youtube.com.
Fisrt you pull the window and door cranks. Next pull off the door panel.Then remove the screws holding the window channel towards the front of the truck they are located on the bottom of the door.The next step is to remove the 3 screws that hold the small vent window in place they are on the outside edge of the door. Then carefully pull out the entire vent window assembly and channel. This now gives enough room to pull out the window,helps to remove the rear channel also.Install is the reverse