Normally you will see moisture, or fluid leaking from the master. Need more help contact me through my board and I will try to help.
After you have located the clutch slave cylinder, have someone depress the clutch pedal. You should see the piston of the slave cylinder extend somewhat. If it does not, either the slave cylinder is bad, or the master cylinder, or, there is not enough brake fluid in the system for it to operate properly. Check the level in the master cylinder. If the slave cylinder is leaking profusely, it is probably bad.
The gasket to your clutch master cylinder is probably broken or cracked. or your master cylinder is bad.
no it is hydraulic.dont know what your problem is but check clutch master cylinder and slave cylinder operation,if ok may just be a bad clutch
clamp the line to the slave cylinder and mash the clutch pedal. if the pedal gets hard to push,the slave is bad. if the clutch pedal goes down slowly with moderate pressure,the master cyl is bad clamp the line going to the slave cylinder. meant to say that in the previous answer
There is no adjustment on that year. You either have a worn out clutch disc or a bad clutch slave cylinder. Could be a bad clutch master cylinder too.
First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.
Does my 1995 Toyota Paseo have a clutch cable
Hydraulic clutch? Maybe a bad rear seal in the clutch master cylinder
It's a self adjusting hydraulic clutch. If it needs adjustment, it's probably either a bad clutch or a faulty clutch master or slave cylinder.
It is notadjustable, You either have a bad clutch slave cylinder, clutch master cylinder. The clutch and pressure plate may just be worn out.
Look for leaking fluid at the slave or master cylinder.
It may be that your clutch master cylinder is bad, or more than likely one of the internal components within the cylinder, have the clutch master cylinder checked.