answersLogoWhite

0


Best Answer

If you suspect your timing belt has broken or the teeth have been stripped off of it, the only way to know for sure is to take off you timing belt cover and have a look. Some vehicles had / have interference heads. These vehicles will destroy their own valves if you try to crank them without a timing belt on.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you know if your timing belt goes out?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you know if the timing belt goes out in a Chevy Tahoe?

That engine don't have a timing belt. It has a chain and gears and it would crank over real easy/freely.


What happens to a subaru 2000 outback went the timing belt goes and the valves bend?

The timing belt goes and the valves bend.


How do you know if your timing belt is going bad on 94 cadillac?

If you think it is going bad STOP DRIVING and get it changed immediately. If the timing belt/chain goes while you are motoring it will ruin the engine.


What happens if a Chevy s10 98 timing belt breaks?

It does not have a timing belt. It has a chain and gears.If timing chain goes out then the engine will not run.


How do you know when the timing belt needs changing on a ford expedition?

It does not have a timing belt it has a chain


Photos of timing belt Kia Rio 2003?

i need to instal the timing belt on a kia rio 2003 how the mark goes


How do you know if your timing belt goes out on a Toyota Camry?

You don't, it's either broken or not there is no in between. Unless you are very lucky and the belt will slip one tooth without braking. You will notice that because the engine timing will change.


Does a 1998 Dodge Dakota have more than one belt Is the timing belt the same as a serpentine belt?

the timing belt is not the same as the serpentine belt.the serpentine belt goes around your water pump pulley and the power steering pump,air condition compressor pulley and the alternator pulley.the timing belt goes around the camshaft and the crankshaft.it is not visable without taking the timing belt cover off.


Does motor have to be removed to change timing belt?

I know of no vehicle where the engine has to be removed to change a timing belt.


What sound does bad timing belt on 1998 ford expedition make?

If I recall correctly. When a timing belt goes bad it just go...


How do you replace a timing belt on a Acura Integra 1995?

Replacing the timing belt isn't that hard of a job. You will have to jack up your car, and take off the driver side tire. This should expose the three belts. The timing belt should be th inner most belt. To make sure you know which belt is the timing belt, follow it and see where it goes. The belt that goes to your cam shaft(located on top of the engine covered by a black cover.) There should be a wheel that the belt goes onto. When the cams rotate, the rotate the wheel, which rotates the timing belt, which rotates the other two belts, keeping everything in time. The bottom wheel should have a bolt on it in the middle of the wheel. If you loosen that bolt, the wheel will be able to move, thus allowing you to tighten or loosen the belt(once it is on the wheel.) So you will have to take off the other belts, and then loosen the bolt on the lower wheel (the wheel that the timing belt goes around) and then remove and replace the belt. This is all from my memory, but if you just get in there you could easily do this job.


How do you know if the timing belt is gone on a 97 Buick park ave?

The 1997 Buick Park Avenue does not have a timing belt. It has a timing chain.