Look for the hole into which the distributor is to go, assuming that it is a bare block you're talking about: the distributor goes up front. jb
The temperature sending unit on a 1977 302 engine is on the front. It is located in front of and to the right of the intake manifold.
Cylinder # 3 on your 5.0 L ( 302 cu. in. ) is on the passenger side of the engine , it is the third cylinder from the front of the engine ( the engine cylinders are numbered 1 , 2 . 3 , 4 from front to back on the passenger side of the engine , and 5 , 6 , 7 , 8 from front to back on the drivers side of the engine )
I know 1 of them is a Boss 302.
I know 1 of them is a Boss 302.
For a FORD 302 cubic inch , V8 engine : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle
A Ford 302 engine, yes. A Chevrolet 302 engine, no.
Passenger side on the very front of the engine.
As you are facing the Front of the engine they are: Leftside 1,2,3,4Rightside 5,6,7,8
For a 1989 Ford 302 cubic inch V8 engine : The # 1 cylinder is at the front / passenger side of the engine firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle
It plugs in at the one o`clock position. Looking at the engine from the front. It is the first hole after the back clip to hold the cap on.
If its like my 94... it should be in front of the driverside back tire. near the gas tank. :) good luck
Yes you can 351 and a 302 are pretty much the same engine block. the motor mount will work.