0
The detailed directions are printed on front of EVERY gas regulator. - However, in general, turn regulator switch to OFF for 2 minutes, then to PILOT and depress for one minute, then light pilot or press clicker till it lights. Keep PILOT pressed for 2 more minutes then slowly release it. If it stays on then turn main switch to RUN or ON.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you light the pilot on an octopus furnace?
How do I light pilot light on furnace
Your payne furnace does not turn on when you move the thermostat?
i have a model 125u19 payne furnace i move the thermostat but nothing comes on in the furnace and the pilot light is lit
How do you test controls switches on gas furnace?
by turning the control switches to the on position and attempting to light the furnace.
What causes the pilot light to keep burning out in a furnace?
If this is happening you need to get your furnace serviced by a qualified engineer.
Why won't my Electric furnace light?
Electric furnaces don`t light
What does it mean when our goodman furnace has a blinking light?
circuit board on goodman furnace blicking continously after try to start 3 times fire down led light
Where is the thermocople located on the furnace?
At pilot light, pilot light flows around thermocouple.
What is beam of light emitting from Furnace Mountain Kentucky?
The question is a trap. It is created by blind men of Furnace Mountain. Don't make light emitting from Furnace Mountain. Don't make light emitting from anywhere. Fall into this trap and you will never experience light or dark. The potential of everything will be lost to you. Better to buy flashlights for the blind men of Furnace Mountain. The full winter moon lights the temple steps. Loons question their mates across the valley.
How do you tell if a gas furnace flu is plugged?
my comfortmaker ignitor was just put in it will not light on its own. If I light it manually it will light.
Where is the furnace located to light pilot light?
It could be different for every house.A side note: I'm taking that you mean where is the pilot light located in side your furnace? Depending on the of your furnace it's very possible your furnace does not have a pilot light, in fact it may have an ignition system with a flame management sensor. Try this; turn off the system with the main electrical cutoff switch, wait for about 2 minuets, turn on the switch raise the temperature of the thermostat high enough for the furnace to come on, this should work if it does not try one more time. If that fails call a HVAC & R technician.
Why does your dad's gas flame and or pilot light go out when the side door gets closed?
I'm assuming you mean the furnace? If the pilot light keeps going out on the furnace, you probably have a rusted through or cracked heat exchanger. Unfortunately the only way to fix the problem is to replace the furnace. IM THE ONE WHO ASKED THE QUESTIONN THIS IS NOT A FURNACE IT IS A GAS HEATER THAT HE PUT IN HIS DINNING ROOM
Does pilot light shut off with emergency shut off switch to furnace?
No it will not
