Close the gun and HAVE FUN! I hope this was detailed enough.
Right underneath the main barrel is another much smaller barrel. Pull on this barrel and it releases opening the gun so that the caps can be placed.
slide the gun openplace the roll on the small metal peg in the gun with the end of the roll towards the muzzle and pointing downthread the end of the roll between the back of the gun and the small metal plate inside the gun (both located just forward of the hammer)pull the trigger a couple of times to feed the strip throughClose the gun and HAVE FUN! I hope this was detailed enough.
Its in the revolver you put the caps in it.
depends on if it is roll caps made of paper or plastic caps they all have different amounts.
Usually cap guns use ring or rolled caps. Check out websites online or hobby stores.
You just unroll is about 3 caps down and insert the first on into the gun. Actually, I think you insert it about half way so the other side of the strip is coming out the other end.
It is possible, but, very expensive and time consuming.
Snap caps are by the size of the shell, not the make of the gun.
It's very hard nowadays to find caps in your local grocery store or dollar store. You can find them on cap gun websites and Amazon but they're usually overpriced and charge excessive prices for shipping.
well there r many places where u can get a good cap gun for egsample:online:amazon, eBay sometimes, the granville stores in woodville. well that's where i got my cap guns and caps from.
This choice is made by the manufacturer, it is not invariant. Even in the 1930s; and no doubt before; cap guns used to have a roll of percussion caps to allow repeated firing.