It is on the left top of the motor on top of the water jacket. It is held on by four bolts. Left from back of motor.
On a 2000 Mercury Sable, the thermostat is typically located at the engine end of the upper radiator hose, where it connects to the engine. To access it, you may need to remove the upper radiator hose and the thermostat housing. Ensure the engine is cool before attempting to locate or replace the thermostat to avoid burns or injury.
Normally the thermostat is located where the upper radiator hose connects to the engine.
Folllow your upper radiator hose to the engine to locate the thermostat housing
Follow top radiator hose to the engine to locate the thermostat housing. The thermostat will be inside the housing.
Most vehicles locate that sensor close to the thermostat housing.
Locate thermostat, on 40 HP it is on the left side of the motor near the top of the water jacket, left side from the back. It is held on by 4 bolts. Remove the flywheel cover, then remove the four bolts holding the thermostat/poppet valve cover. Pull out the thermostat. Be sure to note of the direction in which the thermostat is facing before removal. Put in new thermostat in reverse order. You may need a new gasket.
To locate the oil drain nut on a 60 hp 4-stroke Mercury outboard, start by tilting the engine up to a comfortable angle. The oil drain nut is typically located at the bottom of the lower unit, near the propeller shaft. It is often a hexagonal or square-shaped bolt. Make sure to have an oil pan ready to catch the old oil when you remove the nut.
To replace the thermostat on a 1998 Cadillac, locate the area you will be working in. The thermostat is located at the rear of the engine on the drivers side. Then locate the upper hose. Remove the upper hose from the housing and disconnect the unit. You can then safely replace the thermostat piece.
Where the upper radiator hose connects to the engine, you will find the thermostat housing. The thermostat is located under this housing. Usually is domed shaped.
follow the top radiator hose to the engine.
My 97 4.0 Ranger's thermostat is in the front of the engine. I has two bolts you have to take off. I had to replace the gasket. Leaked when I got on it hard. It's called the "thermostat housing. Thermostat is easy to replace. Great engine.
The thermostat is quite easy to locate. It is at the top of the engine at the front. You will see a radiator hose attached to the engine at this location. The thermostat is in the housing it attaches to.