The main frame of the robot, the body which holds the motor, wheels, the receiver of the Remote Control kit and the batteries.
Motors can be used to drive a car which uses differential turning mechanism. This is the simplest steering possible and is achieved by turning one motor on and the other motor off to achieve steering. The on and off controlling of the motors is done by using the remote control.
The chassis is where you can really apply imagination to make the chassis as light as possible and suitable according to the challenge. What is essential to realize is that the weight of the motors is pretty standard and can't be reduced beyond a certain extent. In a robot with limited power supply (i.e. a battery) the power to weight ratio has to be kept maximum. This can be done by limiting the weight of the chassis. Chassis can be made out of:
In a race, the lightest chassis is usually the best, whereas in a Robowars kind of challenge, a heavier chassis might be advantageous.
REMOTE CONTROLLED KIT:
Making a remote control kit at the beginners level is a hard thing to do. I would suggest you go in for a readymade kit which is available online and requires no experience to run and is fairly a beginner proof.
Check out
www.robokits.org
BATTERIES:
Used for supplying power to a remote controlled car, rechargeable batteries are usually the best ones. I suggest you visit this shop called Pitambara at Lamington Road which sells only batteries. Otherwise a standard 300-500 RPM motor runs well between 9 to 12 volts, and alkaline batteries of the brand Camelot or Zinc carbon batteries of brand Hi Watt. The appropriate series parallel combination can be used to provide more power than a standard battery can provide.
MOTORS:
For a remote control car, we use Geared DC Motors. A DC motor is a low torque, high RPM motor which has to be geared down to reduce the speed and increase the torque. The gearing is done internally in motors available in the market.
Motors convert electrical energy of the batteries to mechanical energy, which is used to drive the wheels. Motors should be of around 300-500 RPM and can be bought for around 200 INR (4 US dollars according to the current rate) at either Hindustan Electronics or Servo Electronics, both at Lamington Road. These motors should be connected with their shafts in a line with each other such that differential turning mechanism works.
WHEELS:
Wheels are mainly of two types in this basic car, one is the type attached to the motors at the back, which are used for steering, and another trolley (castor) wheel in front, which allows 360 degrees free rotation and avoids friction on the ground. The wheels can be put on the shafts either by using screws or by wrapping the shaft with masking tape first. The trolley wheel and masking tape are available at any Hardware Shop. The other two wheels may be bought out from a good collection at Servo Electronics.
by:thinesh kuganeswarasarma
how to make a remot control car in hindi language
You can control the car by remote AP1
How to make a wireless remote control car plz give circuit diagram
G00 gle
remote control
sir how to make a car with camera household materials
No you CANT a different remote control for a different car
eBay or an RC store
the remote car was invented in austrailla in 1879
One can fix the transmitter of a remote control car by going to the store where the remote control car was originally purchased, in case said store has a warranty policy.
The Canon remote controller RC 1 is used to control the RC 1 remote control car. A remote control car is usually a small car that can be controlled from a distance with a controller.
Transform it :D