Want this question answered?
You would usually use a magnet, which is just called using a magnet.
You can destroy the magnetism of a magnet by hammering ,heating or using a alternating current method.
You could do this using a magnet, Iron filings are attracted to a magnet, aluminium filings are not.Hint: magnetism, investigate the relative magnetic properties of the metals.Iron is a ferrous material, and aluminum is non-ferrous. A magnet would separate the two materials as the iron would be attracted to the magnet while the aluminum filings would not. The term ferrous basically refers to any material which contains iron.
One commonly used method to separate aluminium pieces from salt is by using a magnet. Since aluminium is not magnetic, the magnet can attract and separate the aluminium pieces from the salt. Another method is to dissolve the salt in water and then use filtration to separate the larger aluminium pieces from the saltwater solution.
Of course . You can make such a magnet easily using a safety pin. Take a safety pin and magnetize it using a permanent magnet. Then unfold it. The ends will have same poles and at the middle you will have the other. So you can have a magnet with three poles. Verify it using compass.
You stroke it with a magnet.That's how you turn a nail into a magnet.
yes
Magnetic Seperation
Repetitively stroke a pin which CID attracted to the magnet in 1 direction for two minutes (stroke, lift, back, down, stroke, etc.). Stick the needle in a cork and put it in some water - one end will point north and the other south.
You would usually use a magnet, which is just called using a magnet.
The closer the lines of force are together, the stronger the magnetic field it represents.
center hold
because battery supplies a direct current and to make a magnet with using the electrical method you need to supply direct current to the material {metal}which must be wounded with a coil {solenoid}.
can be separated by using a magnet
You can destroy the magnetism of a magnet by hammering ,heating or using a alternating current method.
When a magnet is weak, you can do three things to try to recharge it. You can rub a stronger magnet across its surface, you can stack them tightly and in the same alignment, or you can place it on something that floats in water, remove it and strike it with a hammer. These methods are not guaranteed to work.
You could do this using a magnet, Iron filings are attracted to a magnet, aluminium filings are not.Hint: magnetism, investigate the relative magnetic properties of the metals.Iron is a ferrous material, and aluminum is non-ferrous. A magnet would separate the two materials as the iron would be attracted to the magnet while the aluminum filings would not. The term ferrous basically refers to any material which contains iron.