You will need a test instrument known as a clamp on amp meter. The test instrument clamps around one of the A/C units feed conductors. From the meter face you will read what the actual current is flowing through the feeder conductor.
This depends upon how much power each cell produces. Most home central air units need 240V, and draw aprox. 24 amps.
100-200 Amperes.
The fuse or breaker should be no bigger than specified for the wiring and devices on the circuit. Your nominal current draw may be 20 amps, but a short circuit would cause maximum current to flow which in this case would be 100 amps until the fuse blew.
Assuming it has the average appliances, heating and cooling systems, electrical outlets, etc, 200 amps should pull it, depending on the heat and air conditioning systems used. <<>> A 200 amp panel is the norm these days for an ordinary 2000 sq. ft. home. A home of 4700 sq. ft. would take a 400 amp service. Calculations on a house sometimes can be complicated, assuming standard equipment and all electric, I came up with a load of 218 amps. You could then use a 250 amp service. Use gas for heating and you could fall around the 200 amp size.
10 to 12 amps at 110 volts, as a surge when the motor first starts up, then about half that during the rest of the cycle.
Minimal 100. Depends on load draw of home. Can be 200 amps or 400 amps as well.
This depends upon how much power each cell produces. Most home central air units need 240V, and draw aprox. 24 amps.
It depends on the amperage's of the appliances. You should be able to draw, Amps = Watts/Volts, 2500/120 = 20.8 amps at 120 volts.
Depends on the amp draw of the items. Most home plugs in the U.S. can safely carry 15 amps.
You can install ducted air conditioning in your home by firstly installing the ductal air systems in your home. After that, you can install the conditioning units on the outside, in order for your environment to be fully conditioned.
There are many companies that will service home air conditioning units. One can get this service from 'The Home Depot', 'Sears Home Services' and 'Trane'.
I'm assuming the electrical system is single phase, such as a home. If not, you need to hire someone to do the work for you. First, 6000 watts at 120v is 50 amps, so if your load is truly 6000 watts, 30 amps isn't enough. If your 6000 watts is 240v, which would draw 25 amps, then 30 amps is plenty. Ten gauge wire may not be placed an a breaker or fuse larger than 30 amps.
An average home nowadays has a 200 amp panel. The dryer and stove use 30 and 40 amps and almost everything else is 15 amps.
max. 100 amps then fuse blows.
200 amps is the average
more that 30
The main purpose of installing air conditioning is to keep your home cool. Another benefit is that air conditioning also lowers the humidity levels in your home thus making it more comfortable.