0
Use a Mega Ohm meter, alaso known as a "Megger". Depending on the type of insulation you need to figure out what voltage to use. The test voltage can range from 500V to 5KV and you have to be sure you know what you are doing and use the right one....
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why multimeter cannot used for measurement of insulation resistance?
Because ordinary ohmmeters are calibrated to measure a range of resistance values that are significantly lower than the resistance of insulation. It should also be realised that we usually test insulation resistance while subjecting the insulation to a high electric field, which a normal ohmmeter is incapable of producing.
Difference between insulation resistance and dielectric strength?
INSULATION RESISTANCE: The insulation resistance is a measure of the capability of a material to withstand leakage of current under a Vdc potential gradient. DIELECTRIC STRENGTH: The dielectric strength is a measure of the ability of the material to withstand a large field strength without electrical breakdown, and is usually expressed in volts per mil (.001') or volts per cm of dielectric.
What is difference between insulation resistance test and polarization index?
Insulation resistance test: This test is used to find the insulation resistance of motor for 1 min or 10 min through high voltage insulation tester. By this we can find the insulation level. Polarization index: This is the ratio between insulation resistance for 10 min to insulation resistance for 1 min.
What is isolation resistance?
I think you mean, 'insulation' resistance! It's the resistance of insulation, normally expressed in megohms.
What is excessive electrical resistance?
High resistance means insulation
What happens to insulation resistance when increasing cable length?
The insulation resistance remains the same throughout the entire length of the conductor.
What is insulation megger draw and explain with neat diagram?
Meggar is a hand driven tool for measuring insulation resistance and earth resistance.
What is meggers?
A megger is an electrical instrument that is used to measure the resistance of insulation by applying a DC voltage to the conductor. One lead is connected to the conductor and the other lead is connected to ground. Safe insulation reading to ground should be above 2,000,000 ohms or 2 megs.
Why the load must be removed when to conduct the insulation and resistance testing?
explain why all the load must be removed when to conduct the insulation and resistance testing
How insulation resistance of a motor winding checked If the insulation resistance is low What is likely to cause?
gbs bbn b b b sdgb
Why is AC meggering not used?
You do not use AC to megger a device, because the purpose of meggering is to measure the insulation resistance of the device. You use DC to do that. If you used AC, you would be unable to differentiate between insulation leakage and capacitance.
When carrying out an insulation resistance test on a walloven with mineral insulated metal sheathed heating elements the minimum permitted insulation resistance is?
0.1M ohms
