0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are snowmobile weights?
the weights are in your primary clutch
How do you rebuild a polaris snowmobile primary clutch?
Purchase a clutch rebuild kit, and a clutch puller tool.
What do you use to lubrcate a snowmobile clutch?
You do not lubricate a clutch - You clean it. If you lubricate it will slip and it will collect dust and dirt from the belt and it will bung it up..
How can one set the clutch on a Polaris snowmobile?
To set the clutch on a Polaris snowmobile make sure you have cleaned the entire clutch assembly and adjust all the bolts to the proper setting. With both of those things done make sure you have properly lubed and set the belt to the right tension.
How do you lubricate a clutch on a 1980 Yamaha 440 SS snowmobile?
You do not "lube" a centrifugal clutch. http://www.snowmobileforum.com/engine-drivetrain/26360-generic-clutch-cleaning-advise.html
How do you get the clutch off your 1986 Yamaha vmax snowmobile?
you need a special puller $30
What is the function of cylinder gauge?
To measure bore taper
Where is the starter on a snowmobile?
it is usually located in front of the engine, right next to the clutch. it looks like a a soda can with a sprocket on it
Where is the starter located on a 1996 arctic cat pantera snowmobile?
Look under the exhaust pipes on the clutch side of the engine.
How do you know that your snowmobile belt is worn?
Cracks, peeling, crumbling, chunks missing, dry rot, also when you notice your snowmobile not accelerating as fast, or you hear squealing from the belt. also if there is a vibration in your sled, a common mistake is that people think there clutch is going bad on there snowmobile, but really its just your belt
How do you put a snowmobile motor in a scrambler?
It takes some fabrication, you have to use the secondary clutch from the scrambler and shim it to fit the snowmobile belt. You will use the snowmobile primary clutch and some cutting and welding to fit the motor in the frame. You will have to fab custom mounts and reinforce the from where the scrambler chaincase mounts to. A big radiator like one from a 96 honda civic fit well. With the electric fan. It's not too hard if you know how to weld and fabricate.
Where on a vehicle clutch system would you measure the clearance?
At the clutch plate and the pressure plate.
