Between the driver side door and the drivers seat there's 2 levers. One for the fuel cap release and one for the boot.
can you manually open front trunk on a 2002 boxster?
Try the key in the trunk lock ...
It means your trunk is open
Oh dear, you need to call a mechanic.
There are 2 buttons on the driver side door sill. The front one is for the front trunk and the back one is for the rear trunk. As long as your battery is not dead, it will open.
Look in line with the steering column on your left side just below the dashboard line you will see a round button. Press to open your trunk. You can also use your remote to pop open the trunk
press the little button with the Jag face on the trunk lid..
looking at the plastic around the whole center control panel i found that i could pull the panel out carefuly from just below the void space there are no screws just some plugs and then unscrew the heater box the cable bracket may be cracked best of luck .liga in Ireland any one know where the fuel reset switch is no my 2002 nubira the passenger door wont open
Connect a freon gauge and can to the low side AC port. Start the car and turn the AC on high. Open the freon valve and fill the system to full on the gauge reading.
Slim to none! Valves will remain open while pistons move upward and usually bend several valves.
To open the trunk of a 2002 Jaguar XK8 with a dead battery, you can use the manual key. Locate the keyhole on the trunk lid, usually hidden under a small cover or trim piece. Insert the key and turn it to unlock the trunk. If the keyhole is not accessible or the trunk remains locked, you may need to access the trunk from the back seat by folding down the rear seats, if applicable.
To change the headlight bulb on a Daewoo Nubira, first ensure the vehicle is turned off and the keys are removed. Open the hood and locate the back of the headlight assembly; you may need to remove a cover or dust cap. Disconnect the electrical connector from the bulb, then twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, ensuring not to touch the glass part, then reassemble everything by reversing the steps.