looking at the plastic around the whole center control panel i found that i could pull the panel out carefuly from just below the void space there are no screws just some plugs and then unscrew the heater box the cable bracket may be cracked best of luck .liga in Ireland any one know where the fuel reset switch is no my 2002 nubira the passenger door wont open
the fuse panel on our 1999 nubira is on the left under the bonnet it's a black plastic box
To remove the heater control panel on a 2002 Daewoo Nubira, start by disconnecting the negative battery terminal for safety. Then, carefully pry off the trim surrounding the control panel using a flat tool to avoid damage. Once the trim is removed, unbolt the screws securing the heater control panel and gently pull it out. Disconnect the wiring harnesses from the back of the panel before fully removing it.
http://www.freepdfmanual.com/2009/05/12/2004-daewoo-nubira-lacetti-maintenance-repair-and-troubleshooting-manual Download this free manual for a daewoo nubira-lacetti. Same car, different name. Everything you ever need to know.
A fuse box diagram for a 2001 Daewoo Nubira can be found on the inside of the panel cover of the fuse box. It can also be found in the owners manual to the car.
The first step to remove a Daewoo immobilizer control unit is to disconnect the negative battery cable. Remove the knee bolster panel and the instrument panel side cover. Unbolt the knee bolster and remove it. Unbolt the immobilizer unit. Finally, remove it and disconnect all electrical connectors.
Remove the instrument panel cover. Remove the instrument panel retaining screws. Remove the wiring harness from the gauges. The instrument panel will come out.
The flasher relay on a 2001 Daewoo Nubira is typically located under the dashboard, near the steering column. You may need to remove the lower dash panel to access it. It's usually a small, cylindrical component that can be identified by its electrical connections. If you have trouble finding it, consulting the vehicle's service manual can provide specific guidance.
you remove it by taking the whole panel off - it is a moulded piece which is integrated into the door panel. there are small plastic screws - 2 located on the side of the panel and two located on the opposite side of the panel - just undo and carefully take the panel off. There is also a screw by the buttons for the electric windows. Hope this helps
remove plastic around instrument panel . remove screws from instrument panel then pull panel towards you to unplug it this will allow to get to dach lights
How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine
My 2000 Daewoo Nubira Sedan does NOT heat up to HOT, maybe warm if I leave it on for an hour full blast heat. The AC doesnt work either. Mainly this is because the panel on the dash that has the temperature controls has a loose wire or something and doesn't fully turn on. Though the air works, the lights in the panel don't turn on and thus the a/c and circulation buttons do not work. Maybe I need a new panel or thermostat for the car.
To remove the instrument panel on a 1987 Mazda B2000, start by disconnecting the negative battery cable to ensure safety. Remove any screws securing the trim bezel around the instrument panel, then carefully pry it off using a trim tool. Next, unscrew the instrument panel itself and disconnect the wiring harnesses at the back. Once everything is detached, you can lift out the instrument panel for replacement or repair.