answersLogoWhite

0

The trunk release is probably a button in the glove box.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is trunk fuse on 1997 Cadillac?

The 1997 Cadillac trunk fuse location is dependent upon the type and model of the Cadillac. The trunk fuse will be in the fuse box. The location should be listed on the inside cover of the fuse box.


Where is the fuse box for horn 1997 Cadillac Seville sls?

in the trunk on the driver side


How does the trunk on 1997 Jaguar XJ6 operate?

button on left side of dash 3rd one in


Keys locked in trunk of 1997 Buick Lasabre?

The trunk switch on the dash should still operate unless the trunk release switch inside the glove box has been turned off.


Where is the fuse box in the trunk of a 1997 Cadillac STS?

MY 95 sts is on the left side quarter panel behind the carpet


How difficult is it to replace the power steering pump on a 1997 Cadillac Catera?

fdgf


What is wrong when you can't open your trunk remotely on a 1997 Cadillac Deville D'Elegance?

check valet button n glove box.it deactivates trunk release. also the contacts inside the remote get dirty,


Where is fuse box in 1999 Cadillac STS?

Not sure about a 1999, but there are 2 fuse boxes on a 1997, one under the hood and one in the trunk. Hope this helps.


Where is the fuse panel in a 1997 Cadillac STS?

MOST CADILLACS HAVE ONE IN THE TRUNK AND ONE UNDER THEHOOD BOTH SHOULD BE ON THE DRIVERS SIDE OF THE CAR. PAUL G


What are the release dates for Cadillac - 1997?

Cadillac - 1997 was released on: USA: October 1997 (Hollywood Film Festival)


Where are the fuse boxes on a 1997 Cadillac Eldorado?

fuses are in the eng compartment, facing the eng , to the right , under the plastic shield, also in the trunk , back section of the seat wall


How do you change a reverse light bulb on a 1997 Cadillac Seville?

To change the reverse light bulb on a 1997 Cadillac Seville, first, open the trunk and remove the trunk liner or access panel to reach the tail light assembly. Next, twist the bulb socket counterclockwise to remove it, then pull the old bulb straight out. Insert the new bulb into the socket, replace the socket into the assembly, and secure it by twisting it clockwise. Finally, replace the trunk liner or access panel and test the new reverse light.