It would be best to go to bgfindashop.com and get a repair shop to do it for you. With the BG flush there is a cleaner put in and then the system is back flushed. The new coolant is added with a rust inhibitor.
I doubt it very much as they change engine specs every year.
I'm not a mechanic
I am changing rear disc brake pads on a 2004 Chevrolet Malibu lt can I get step by step instructions to make it easier for me.
Remo0ve oil pan for access
there is no gearbox. get a haynes manual. rack or pump.
Remove the belt from your 1999 Chevrolet Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining nuts. Reverse the process to change to the new alternator.
p0128-- coolant temperature below thermotat regulating temperature---change thermostat first, and make sure coolant is ok!! then if it does not work. change coolant temperature sensor.
Pull the complete headlight assembly out to get to the bulb.
How many people of (insert race here) do you have assisting?
You need to purchase a Haynes manual and it will give you detailed instructions.
It is in the main power distribution box under the hod.
The belt is bad if it has 3 cracks per square inch.
Read your owners manual as there are too many types of radio's anymore.
If the Red Coolant meets the specifications required by you vehicle manufacture you can perform a coolant flush on you system before replacing with the new coolant type.
If your brake is leaking,Its easier to replace with rebuilt ones,then to change the piston and seal,. And you should change both
go by the recommended mileage in the scheduled maintanence section of the owner's manual.
For a complete change it's going to take 10 qts.
i have a 1997 chevrolet Malibu with a po113 code. the car has been sitting up for about a one year can it just need to run for a couple of miles or what do i need to do?
It would be to your advantage to have the system power flushed. That does not require replacing the filter.BG Products has an excellant product.
Fluid and filter change: 7 qts From dry, including torque converter: 13 qts
The best thing you can do if you are going to do this rather than have a repair shop is to purchase a Haynes Manual that is specific to your car.
At 50,000 miles maximum is my recommendation. Your owner's manual may have a different mileage listed.
Remove the intake manifold retaining bolts on your 2003 Chevrolet Malibu. The manifold will come off. Remove the manifold gasket and clean the surface. Put the new manifold gasket on and reverse the process.
how do i change my blower motor on my 2007 malibu
The best way is to use a coolant flush machine, as it takes fluid out, it puts back in the same amount. This way the system does not get air bound.