You have to fix the cause of the trans codes.
A bad knock sensor would illuminate the check engine light and allow the engine to ping (spark knock). The engine doesn't shift, the transmission shifts.
I want to check the level of atf temp in my subaru forester 2010. On checking the transmission fluid level, after the car was driven about 10 km and was put in each gear and setting the select level in the "p", do i have to turn off the engine or idle the engine before i check the atf level?
in the engine in the engine in the engine
It will usually come on. The speed sensor on my transmission died and it displayed the check engine light.
Answer There is a dip stick at the back of the engine. Start your engine first, let it run and check your transmission oil level. You only check transmission oil levels when the engine is running, other oil levels have to be checked when the engine is warm to hot but not running.
Check engine oil when you have just finished driving. Check Transmission fluid when the car is running and the transmission in in N (manual) or P (automatic).
If you have an automatic transmission, check with the engine warm and running, The dip stick is located on the passenger side rear of the engine.
The transmission dipstick is on the front of the engine on the drivers side. This is the place to check as well as add transmission fluid.
Yes it does. The proper way to check automatic transmission fluid is to check it while engine is at idle.
The Honda Rincon uses engine oil as transmission fluid so when you change your engine oil or check your engine oil level you are also changing or checking the transmission fluid at the same time.
Car on level ground. Engine warm- low idle. Parking brake must be working, Engine running, transmission in neutral. Check transmission dip stick.
You should check the battery,transmission, and maybe the engine