You can not use a 10 switch for an 8 switch. I just had to call a lock shop for the info.
still trying to figure out
the steps is 1- Keep your hand on the switch for unlock the door 2- Make key switch on and off for 3 times without run the car only on then of 3- You will hear the horn one beep this mean you can start program the remote control 4- Then keep pressing the two switch at the same time for remote control lock and unlock for around 10 second until you hear the door is on remove your hands 5- then make key switch on you will hear the horn for 2 time this mean confirm program
Turn ignition switch from OFF to ON 4times within 6seconds,leave ignition switch in the ON postion,Chime should sound to indicate that its in the learning mode,Within 10 seconds press any button on the remote transmitters,Do all other transmitters at the same time.
switch ignition on press lock button for 10 secs switch ignition off leave for 5 secs your remote should be coded
You need to switch the ignition lights on and off about 20 tomes in 10 seconds to disable the kill switch and activate the remote frequency learning module in the vehicle. At this ponit push the button on the new remote and the doors central locking system should activate when the new code is accepted. No one else is smart or resourceful enough to know this
To program the remote with the codes, firstly, turn on the electronic gadget for which you are going to use this remote, by pressing the On and Off button. Then locate the Setup or the Code Search key on the remote control. These buttons may vary from remote to remote. Just hold on the setup or the code search key for 5 - 10 seconds or till the light on the remote
If it is a remote for locking and unlocking doors; with doors all closed, turn ignition switch on and off 5 times within 10 seconds, then press one of the remote buttons within 10 seconds. A small red light will illuminate if remote is working.
You can program the remote start by holding the start button down for 10 seconds. The start light will illuminate. With the start light illuminated hold the start button down until the engine start.
There are 2 types. Some have a small switch in both the remote and the opener with 9 or 10 little switches which have to be set in the same order. On or off. The other kind has a button on the opener that you push and it should either flash or stay lit and you have 30 seconds to press the remote and the opener records it's frequency and is automaticly set.1. Remove light cover. 2. Press and hold transmitter button on remote. 3. Press and hold red receiver button. 4. Release both buttons when opener light flashes twice
To program a Mazda # remote first open the driver car door and leave open, then lock and Unlock the drivers door using the power door lock switch on the door. Put your key into the ignition and turn it on then off and repeat this 3 times in 10 seconds. Leaving the key in the off position, open and close your driver's side door 3 times, and leave door open. You should hear a locking and unlocking once then press #1 on remote and doors should lock and unlock.
# Sit in car, doors closed. Electronically unlock all doors using the power door unlock switch on the driver's door. # Insert key into ignition switch and turn from OFF to ON 8 times within 10 seconds with the 8th time ending in the ON position. (5 times on some models) # The doors should lock and unlock by themselves to signal programming mode. # Using your remote: lock the doors.
I have the same problem but I have a Yaris. Try turning the engine on and off 10 times. That's what ford does.
The RKE harness (remote keyless entry) is located under the center console. My guess is your looking to program a remote. The wires you jumper to do so are A and G. These are purple and black. -jeff