I just did programmed my key-less entry this morning after looking for about 5 hours.
OK so first locate your computer hookup under the dash, it should have 2 rows of 6 plugs.
Grab a piece of wire and put one end in the very bottom left hole, if your looking at it from the front of the seat. ground the other end of the wire to the truck. Your truck should lock and unlock meaning it is in programming mode. leave the wire in the plug and make sure it is still grounded, hold it if needed.
Take your key fob and hold the unlock and lock button until the truck unlocks and locks again. take the wire out and test the key fob. Repeat this if need for another key fob.
if you need anymore information i will include the link to the website i found that on later.
Here is a link to the website that i used, this site can be used for other cars. look up your make and model.
http://www.programyourremote.com/classified/DisplayAd.asp?id=1460
programyourremote.com simply put.. "Program Your Remote.com"
I bought a 1997 dodge ram 1500 larmie and the seller lost the keyless enrty. who do i get a new keyless entry? will i have to reprogram/replace anything on the truck
Yes, some of the 1996 Dodge 1500s did come with keyless entry. It was not standard equipment.
It can have power locks with out keyless.
It requires the dealers scan tool.
If you call your local dealer with the VIN they can tell if it was built with key less remotes.
Yes when I test drove my truck at the used car dealership where i bought it from it had keyless entry but when i went to pick it up the next day the took the remote off. Been trying to get it from them but they said they didn't know anything about it.
You will need a scan tool to do that.
To program your keyless remote, locate the dark green program enable wire and connect to the wire enable terminal. Insert your ignition key and turn the switch to on while depressing either button on the transmitter. Disconnect the program enable wire terminal and remove the key from the ignition.
It requires the Dealer's scan tool.
The factory scan tool is required.The factory scan tool is required.
Yes, it could.