To program your keyless remote, locate the dark green program enable wire and connect to the wire enable terminal. Insert your ignition key and turn the switch to on while depressing either button on the transmitter. Disconnect the program enable wire terminal and remove the key from the ignition.
It requires the dealers scan tool.
It requires the Dealer's scan tool.
You will need a scan tool to do that.
Yes, it could.
programyourremote.com simply put.. "Program Your Remote.com"
The factory scan tool is required.The factory scan tool is required.
It can have power locks with out keyless.
That requires the dealer's scan tool.That requires the dealer's scan tool.
To program a keyless remote for a 2003 Dodge Ram 1500, first, sit in the driver's seat and close all doors. Insert the key into the ignition and turn it from "Off" to "On" four times within 10 seconds, ending in the "On" position. The locks should cycle, indicating the vehicle is in programming mode. Press any button on the remote; the locks will cycle again to confirm programming. Repeat for additional remotes if needed, then turn the ignition off to exit programming mode.
It was an option, but very few had it.It was an option, but very few had it.
My 98 Ram sport does it is a control module behind the dash if your does not and can be installed quick at the dealer .
Yes, some of the 1996 Dodge 1500s did come with keyless entry. It was not standard equipment.