My 1994 manual says on page 10: 1. Sit inside of vehicle and close all doors. 2. Place ignition in off position. 3. Open drivers door and leave open during programming procedure. 4. Move the mechanical door lock lever to the LOCK position. 5. Turn ignition to the run position. 6. Aim the transmitter at the Keyless Entry receiver in the overhead console or in the dome light assembly and press the Lock button. 7. Hold the button until the light on the transmitter blinks twice. 8. Turn ignition off within 20 seconds. 9. Check receiver memory by cycling the door locks using the transmitter 10. Up to 4 transmitter can be programmed into a vehicle. I typed this exactly as the manual says it. Hope this helps. OneshotCody vls@juno.com
dealer has to do it with factory scan tool
the dealer does it with a scan tool
it has to be done by the dealer. =(
Cherokee Laredo, no. Grand Cherokee Laredo, yes.
You have to program it with a DRB (Scan tool).
this is located in passenger door switch
I mean how do you disassemble the fan blower in a 1998 Jeep Grand Cherokee Laredo. how do you remove the blower fan from the car in the Grand Jeep Cherokee Laredo.
No.
I had the same problem. Google "keyless entry remote 2003 Jeep Grand Cherokee".
No, they will not interchange.
What is the firing order for a 1995 Jeep Grand Cherokee Laredo?
yes There was also a Laredo package for the XJ Cherokee in the 1990's.