Follow instructions
Close all doors, trunk, and hood.
The alarm must be disarmed. The key needs to be removed from the ignition switch.
Open the trunk and leave it opened.
Open the driver's door and sit in the driver's seat.
Close the driver's door.
Cycle the ignition switch five times between the OFF position and position 2.
The red LED will illuminate continuously, and the siren will chirp once, to indicate that the code learning mode has been started.
The ignition switch cycling must be performed within 10 seconds.
The above sequence must be performed within 45 seconds.
Open the driver's door and remain seated in the driver's seat.
Close the driver's door.
Press and release any button on the remote that you want to register into the module. The status LED will shut off momentarily to indicate that one ID code has been registered.
Open the driver's door and exit the vehicle, leaving the door open.
Close the trunk.
Close the driver's door. The LED will turn off and the siren will chirp twice.
The initialization procedure is now completed.
-------------------------------------------------------- Follow instructions
Close all doors, trunk, and hood.
The alarm must be disarmed. The key needs to be removed from the ignition switch.
Open the trunk and leave it opened.
Open the driver's door and sit in the driver's seat.
Close the driver's door.
Cycle the ignition switch five times between the OFF position and position 2.
The red LED will illuminate continuously, and the siren will chirp once, to indicate that the code learning mode has been started.
The ignition switch cycling must be performed within 10 seconds.
The above sequence must be performed within 45 seconds.
Open the driver's door and remain seated in the driver's seat.
Close the driver's door.
Press and release any button on the remote that you want to register into the module. The status LED will shut off momentarily to indicate that one ID code has been registered.
Open the driver's door and exit the vehicle, leaving the door open.
Close the trunk.
Close the driver's door. The LED will turn off and the siren will chirp twice.
The initialization procedure is now completed.
--------------------------------------------------------
6
The oxygen sensor bank 1 is located in the exhaust manifold. The oxygen sensor bank 2 on the 1996 BMW 328is is located in the head pipe.
It is most likely the climate control fan. This is normal in a BMW
I tried to open my door in extreme cold and the door broke. I need adiagram of theee locking mechsnism.
The standard features on a new BMW 745 include dual exhaust, auto-dimming door mirrors, heated door mirrors, memory seats, and remote keyless entry system.
Mini Cooper dealer is the only one that can set the keys. BMW can't even do it. Take it to a Mini dealer for that. Don't trust anyone else as they can screw up your entire electrical system. Just another 'perk' for we mini owner's!!
Take the remote to any DMW dealer. They have to match the VIN mumber to the remote code. There may be a small fee involved.
Optima/12 Volts, 800 CCA (1000 CA) Red Top Automotive Starting Battery with Post Terminals
Many ppl might say 4 but in reality there are only 2 and it's about $100 a piece if u want to replace them.
you dont need a negative terminal. its just a ground. i had to jump my 328is and i just put the negative cable to the top of the block.
well first you have to check and make sure your canooter valve ain't clogged, then u took the old one out and put the new one in....
http://forum.e46fanatics.com/showthread.php?t=451510