Want this question answered?
How do you program a an ignition key for 2008 Chevy truck
In order to program a key on a 2004 VW Passat, you need to first put the existing key in the ignition.
When you say program, do you mean make the ignition cylinder so you can insert the key and turn it to start the vehicle? If so you can bring it to a lock shop and have them program the key.
you have to take it to a dealer.cost about 150.00 they have to program key to the car.
you can program a key if you already have two known good keys. if not you will have to pay the dealer or a locksmith
1. Close the vehicle doors.2. Turn OFF the ignition.3. Remove the key from the ignition.4. Press and hold the driver side door lock switch in the UNLOCK position.5. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)6. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)7. Insert the ignition key into the ignition lock cylinder. (Do not turn the ignition key in the lock cylinder.) Leave the ignition key in the ignition lock cylinder.8. Release the door lock switch. The vehicle will sound three beeps in order to verify the Program Mode has been activated.9. Press the LOCK and UNLOCK buttons together on the keyless entry transmitter and hold until the vehicle beeps twice to verify that the transmitter has been successfully programmed (this take approximately 15 seconds).10. Perform the previous step to program up to four transmitters (including your old ones).11. Remove the ignition key in order to exit the Program Mode
I made a new key made and now the car will not start: I need instructions onj how to manualy program the key:
no. required computer to be plugged in to the car
The key is only available pre cut from the dealer. The dealer will also have to program it.
To program a Toyota Camry key first open the driver's side door and close all other doors. Insert the key into the ignition two times within five seconds. Close than open the driver's side door. Put your key in ignition and pull it out quickly. Close driver's door and open it. Put the key back in the ignition, close the door and put the key to the "on" position. Remove from ignition than listen for the door locks to cycle.
put the red coded key in the ignition turn it to position 2 quickly 3 times listen for a beep once the beep has sounded leave it in the ignition press one of the buttons on the key in the ignition the the same button on the new key fob that will program the new fob signals to the origanl.
You cannot copy it your self you need a locksmith or the dealer to program it.