Want this question answered?
Need to know if it is possible to program a charter remote to Magnavox sdtv converter box
You must access the menu fuction.Autosearch or manual add or erase channels.
In programming a ds converter using an RCA universal remote, it is necessary to find the code for the remote. This can be done by turning devices on and pressing search. It will rotate through and stop when the successful setting has been reached. Switch to each additional device that needs to be connected on the remote and perform the same function. This will program all devices to work off the universal remote.
I have read 8046 or 8222 but did not gt them to work, purchased a $5.00 universal GE 4 device remote at wal-mart #24944 and using the auto scan on sat it was almost one of the first ones .. and would allow programming so I was able to scan and set channels. Good Luck bc
ge
how do i program a charter remote to a rca tv
You can probably program your Comcast remote to work with it just fine.
The steps below can assist you in programming the remote to your Magnavox TV or any other TV with our DISH remotes. Addressing Remote to TV: 1.) Press and hold the clear TV button until all mode lights light up. 2.) Release and TV light will be blinking. 3.) Enter code and press #. The TV button should flash 3 times. 4.) Try functions (Volume, Power, etc..) and see if it is working. 5.) If no function, repeat steps 1-4 with another code.
How do I proram an Adelphia remote to work with a Samsung T.V.?
The remote codes for a Zenith TV VCR combo vary greatly based on the model of universal remote. Some use 153 and 154, while others use 172.
Found a solution that works well... I picked up a Sony RM-VL600 universal remote with learning capability. With this unit, I've been able to program all the functions of the TB100MW9 DTV Converter box. I picked up this unit at Walmart for $25, but have seen it on Amazon for as little as $16. This remote is a vast improvement over the remote that comes with the Magnavox DTV converter, and was easy to program. Found another solution.... after tinkering with the Philips universal remote for an hour, i finally found a code that can control the magnavox converter. the code is 0759. the Philips remote i have is SRU3006/27 but it might work for any Philips universal remote. the remote itself cost me about 15 dollars. if you call Philips or magnavox they would say none of the remotes can operate the converter.they obviously didn't know their own product...
Here are some codes I found online but none seem to work for my remote. Codes for Magnavox TV when using RCA Universal Remote: 006,007,010,011,013,016,027,033,035,043,066,087,089