I dont know how to pull out the air bag fron the steering wheel
undo wing nut on inside lip of the finder and pull white tabs on top of headlight and pull headlight out. will take 2 minutes
Dont think this question can be answered Why is it chiming? if its because a door is open just pull the dome light fuse.
37
Open rear hatch and remove 2 screws that hold tailight on and pull out
Remove the cupholder trim pieceDisconnect the electrical connectors.Remove the nuts from the side of the front floor console behind the axxess doors.Remove the nuts from the rear of the front floor console. lower rear corner may have to move seat all the way foward.Lift straight up on the front floor console and pull back in order to remove the console from the vehicle.
To change the refrigerant in a Buick Rendezvous you will need to remove the old freon. Freon is bad for the ozone, so you will need to hook to a special machine and reclaim it. Next you will need to pull a vacuum on the ac syatem, then fill with new freon.
might be a groumd or a loose connection pull it apart and check all the connections
look for screws or bolts holding it on look behind door handle for screw or a bolt if none it should pull off becarfule the clips inside break easy
1) Twist it coulterclockwise, then pull it out or 2) Repeatedly strike it with a large hammer until it pops off.
It's under the rear seat cushion. Lift up the front edge of cushion and pull forward to remove the seat cushion. Check in the owner's manual.
I own an 04 and the filter is located behind the glove compartment- just open it up and it should be in the back there- just pull it out.
The 2003 Buick Rendezvous has the most common hook-end wiper arms on both front and rear. See the Sources and Related Links section below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.