The engine and transmission are removed together out the bottom.
The engine and transmission are removed together out the bottom.
The engine and transmission are removed together out the bottom.
My 2002 Chrysler Sebring has 154K miles on it and the front end rattles when it goes over bumps. When I jack the car up and push in and out and side to side on the wheels their is no movement. Nothing seems to be lose when I pull on the front end. I had the same problem on my 2002 Sebring Lxi Sedan. Problem was worn swaybar linkage and bushings. I had the linkage and bushing replaced and the rattling disappeared.
On the turn signal indicator arm. Switch on the headlights, make sure the high beam is off, then pull out the rotating light switch.
Chrysler does not have a kill switchChrysler does not have a kill switch
Pull out old, insert new.
It is the IOD fuse. It does not disconnect all items, but it does stop most parasitic draws.
Under the hood right above the head lamp are 2 torx screws - 1 on each side. Remove each screw then pull the entire headlamp assembly out. Twist and pull the bulb sockets to remove them.
peel back the trunk liner.....should be two or three screws. unscrew and pull the entire light assembly out its a pain in the but!
go under hood reach down where headlight is turn the light counterclock wise and pull bulb out then twist bulb and it will come out.
Behind the rear seat. Pull up on the seat bottom to release the seat bottom from the car, remove the bolts anchoring the seat back to the car, push upwards (towards the roof) to disengage the clips, and lift up the insulation to expose the pump
# Slide your fingers underneath the bottom part of the seat from the front. # Pull up. Hard.
The convertable top is operated by an electric motor operatedhydraulic pump. The assembly is located under the rear seat. This assembly is not serviceable. To get to it you have to bottom rear seat back about 1 inch and lift up and pull forward.
Depends on what you are trying to drain ... please be more specific on which fluid needs to be removed.