answersLogoWhite

0

Under the hood right above the head lamp are 2 torx screws - 1 on each side. Remove each screw then pull the entire headlamp assembly out. Twist and pull the bulb sockets to remove them.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you get to the fuel pump on a 1998 Chrysler Sebring JXI convertible?

You have to remove the fuel tank.


How do you replace the alternator in a 2000 Chrysler Sebring convertible?

When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.


How do you replace the starter on a 2001 Chrysler Sebring convertible?

Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


Where is the convertible top motor located in a 2002 Chrysler Sebring?

It is behind the rear seat. You have to remove the seat to access.


Where is the hydraulic motor in a 1999 Chrysler Sebring convertible?

It is behind the rear seat. You remove the rear seat to access.


Where is the hydraulic pump for a 1996 Chrysler sebring convertible?

It is between the rear seat back and the trunk. You have to remove the rear seat to access.


Location of shift solenoid b for 97 Chrysler sebring convertible?

The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.


Where is the battery on a 1997 Chrysler sebring convertible?

It is located in front of the left front wheel, inside the fender. You have to remove the wheel and fender liner to access.


Where is the horn located on a 2008 Chrysler Sebring convertible?

The horn on a 2008 Chrysler Sebring convertible is located behind the front grille, near the center of the vehicle. To access it, you typically need to remove the grille or the front bumper cover, depending on the specific configuration. Ensure the vehicle is turned off and take necessary safety precautions when working on the car.


How do you replace the convertible top motor on a 2000 Chrysler Sebring jxi?

It is located behind the rear seats. Once you remove them you will see the pumps and lines. There are several youtube vids on how to remove and replace it.


Where is the thermostat in a 2004 Chrysler Sebring convertible?

The thermostat for a 2004 Sebring Convertable is in under the water outlet for the BOTTOM radiator hose. This is behind the alternator which will have to be removed, after you remove the belts. Plan on an afternoon of work. Hope this helps.


Where is the battery located on a 1998 Chrysler Sebring 6-cylinder JX convertible?

it is located in the front drivers side wheel well. you need to remove a few screws to get to it.