answersLogoWhite

0

How do you pull the cord?

User Avatar

Anonymous

12y ago
Updated: 5/21/2022

it depends on what it is on.

User Avatar

Alvah Stokes

Lvl 13
3y ago

What else can I help you with?

Related Questions

If your lawn mower has a key start and a pull cord do you still need to charge the battery or can you get by with just using the pull cord?

You can start it by using the pull cord, just be sure the key is in the ON position.


How do I replace the generator pull cord?

To replace the generator pull cord, first, remove the old cord by unscrewing the cover and pulling out the remaining cord. Next, thread a new cord through the hole in the cover and tie a knot at the end. Wind the cord around the pulley and reattach the cover. Finally, test the new cord by giving it a gentle pull to start the generator.


How do you replace pull cord on xlt polaris?

To replace the pull cord on a Polaris XLT, start by removing the cover of the recoil assembly. Carefully pull out the old cord and note how it is wound around the spool. Attach the new pull cord to the spool, ensuring it's securely tied, then wind it a few turns in the correct direction. Finally, reassemble the recoil cover and test the pull cord to ensure it functions properly.


Will think oil in a lawn mower cause the pull cord to be tight?

No the pull chord will not cause the pull cord to be tight. The coil on the lawn mower will cause the compression to be tight.


How do you replace the pull cord on a ryobi trimmer?

first u need to remove the screws holdiny the pull cord housing then u remove it and pull the old cord out and hold it then remove the end of cord that has the knot to keep it in place wen u install new one do reverse but dont let the cord wheel go back


When riding the bus do you pull the cord at your stop or do you only pull the cord when you'd like to get off at a place without a stop?

When your riding the bus, you only pull the cord "When You Reach Your Stop". Remember don't pull the button unless your getting off, because less stops get you to your destination faster!


How do you start a whipper snipper?

pull the cord


How do you use a parachute?

pull the cord?ok


How do you remove the starter pull-cord?

it depends on what it is on.


How do you operate a pull switch ceiling light?

To operate a pull switch ceiling light, simply pull the attached cord or chain downwards to turn the light on. Pull the cord or chain again to turn the light off.


What would cause your pull cord to not pull?

The most common reasons for a pull cord to not pull are a jammed engine due to a mechanical issue or a lack of lubrication in the engine components. Other possible causes could be a tangled or frayed pull cord, a malfunctioning recoil mechanism, or a seized engine due to lack of use or improper storage.


How do you replace pull cord bolens BL100?

To replace the pull cord on a Bolens BL100, first, remove the engine cover by unscrewing any bolts that secure it. Then, take out the old pull cord from the recoil starter assembly. Measure and cut a new cord to the appropriate length, thread it through the recoil assembly, and tie a secure knot. Finally, reassemble the cover and ensure everything is tightly secured before testing the pull cord.