You hold the string in place on the plastic base and then you roll it around and around till it is over or you can tape it to the base. i would reccommend duck tape.
There are several ways to put the string on your Yo-Yo, here is one. A yo-yo string is one long string, folded in half, and twisted. The end where the two string meets are tied together to make a loop, eventually used to make a slip knot for your finger. The other end, where the string is folded together is where the yo-yo sits. Untwist the folded end with your fingers in order to separate the two strings. Untwist it large enough that the yo-yo can be placed between the strings, so that a single string sits on the axle of the yo-yo, as shown below. Then simply let the yo-yo string re-twist together. The string is now installed on the yo-yo.
The easiest way to loosen a yo-yo string knot is by hand, although that may be time consuming. You may also simply put a new string on the yo-yo.
Knots in My Yo-Yo String was created in 1998.
Be sure the string is looped, not tied around the axle. Look for knots in the string. Untwist the string a little so the axle can spin freely within the loop at the end. Check to see if the string is tangled inside the yo-yo or screwed into the axle threading. If the string is tangled inside a non take-apart yo-yo and you use a paper clip, scissors, or other sharp or metallic object to remove it, be very careful not to scratch the axle or inside of the yo-yo as this will quickly cut through your string.
"Knots in My Yo-Yo String" by Jerry Spinelli has 208 pages.
plastic and string
yes they do
Yo Yo
The main character in Knots in my yo-yo string is none other than the author, but during his childhood.
You manually wind the string around the yo-yo's axle, creating potential energy. When you release the yo-yo, the potential energy is converted into kinetic energy, causing the yo-yo to spin as the string unwinds.
your foot
the thing where the string comes from is the o and use the string to make the y