well it depends on what type of bike you have ,but i have a 49cc x7 super pocket bike, and i had to remove the fuel tank,which the battery is located under there should be three screws which require an Alan wrench to remove one should be located just in front of your tank it screws into the frame and the others are located just under the front of your seat removal of seat may be required to reach them, after that everything should be pretty easy.
Follow the instructions on Youtube.
Take the battery out, clean the battery pocket, and put the battery back in.
you go to lockerz and there would be a whole bunch of stuff for free you just need to put your address so they can send you the iPod or other stuff you want to go to search you type in pocketbike and you crack the web site and you get a ticket and you go to the store and they give you a pocketbike.
* take your battery out * put your battery back in * turn your phone back on. !!
Changing the battery on a Mazda 6 is very easy to do. You will first need to remove the bar that is over the battery, then you will need to remove the battery terminals. After the battery is removed, put the new one in and put the battery terminals back in place, and put the bar back on.
You put the battery back in and you charge it
Take the battery out of the back then put it back in
Yea
pull the battery out and put it back in
It is very easy to change the battery in a 2004 Ford Escape. You will need to remove the bar that is covering the battery first. Then you will just need to take the battery terminals off the battery and then remove the old battery. Put the new battery in and put the terminals back on in the correct order. Then put the bar back over the battery and it is ready to go.
Take both cables off. Remove old battery. Put new battery in. Put cables back on.
The battery should have one bar that holds in in place unscrew the nuts that hold the battery down , take your negative battery cable off, next take your positive battery cable off take battery out put the new battery in put the negative cable back on then your positive cable back on put your hold down bar back on tighten your nuts. that's it