Want this question answered?
The only explanation of tempering is in metal manufacturing. Heat metal to cherry hot, plunge metal into water to quickly cool metal, hardened metal is created
it is covering outside the cylinder of an engine. it is added to the cylinder head and walls in order to increase the surface area that can radiate the heat to the air pgassing by.
The metal spoon will cool faster because it has a lower heat capacity. After several hours they both will feel the same.
Heat travels from warm to cool.
choices are: The cold will flow from the metal into the hot water, causing the hot water to warm up and the metal to cool down. b. The energy from the hot water will flow into the cold metal, cooling the water down and heating up the metal. c. The cold will flow from the metal into the hot water, causing the hot water to cool down and the metal to warm up. d. The metal will cool down because the specific heat of water is high.
Heat the metal red hot. To harden the metal, cool it quickly by dunking it into cold water. To get a soft metal, let it cool slowly.
The heat expands the metal.
Probably because heat expands and cool contracts! That's the same term!
Tea in a metal cup would cool down relatively quickly, since the metal cup wall conducts heat very well.
the spoon is metal and metal conducts heat , if you put a metal spoon in a drink the drink will retain the heat but if you take it out it's like your taking a whole lot of heat, in other words a metal spoon is like a magnet of heat it you remove the spoon it will remove heat but if you keep it in the heat will stay.shoraye khatter.
Because metal is a good conductor of heat it absorbs heat from material touching its surfaces, and transfer to air.
The only explanation of tempering is in metal manufacturing. Heat metal to cherry hot, plunge metal into water to quickly cool metal, hardened metal is created
This depends on the metal, but for most metals, the answer is : heat the metal to red heat, then cool it slowly. This is called annealing. copper is one of the exceptions. To anneal it, get it red-hot then dunk it in cold water.
You can try heating the metal lid to expand it and make it easier to open the jar. Alternatively, you can cool the metal lid to contract it, which may also help loosen its grip on the jar.
plasticstyrafoam iron. the metal conducts heat, the plastic insulates (holds the heat in) - about what you said, the metal does conduct heat, so that the hot sides help to heat up the drink.
it is covering outside the cylinder of an engine. it is added to the cylinder head and walls in order to increase the surface area that can radiate the heat to the air pgassing by.
Because metals are usually good conductors of heat. When you touch metal at a spot that's cooler than your skin, the bit of heat that flows from your finger to the metal at that spot quickly flows onward to cooler parts of the metal ... leaving that spot still cool, and still taking heat out of your finger. If you waited around until the entire piece of metal warmed to the temperature of your skin, then the metal wouldn't feel cool any longer.