0
Adjust it.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you release the tension to install the serpentine belt on a suzuki aerio?
15 mm wrench Put it on the tension pulley and pull to take tension off belt
How do you relieve tension on serpentine belt of 97 buick park?
put a wrench on the tensioner pully and pull it to release tension on the belt
How do you change the serpentine belt on 1990 Buick Reatta?
Put a socket and ratchet on the tensioner belt pulley. Pull to the side, releasing the belt tension. Remove the belt and put the new one on, a helper will make this easier. Take the ratchet off to re-tension the belt.
How do you replace belt on toro snowblower?
put the belt on the bottom pully then on the top engine shaft then put both parts of the belt under the belt tension then the belt tensioner should be on the top of both part (strips) of the belt.
How to replace a serpentine belt on 1994 buick lesabre?
replace tension put it on
What do you need to loosen to change the serpentine belt on a 4 cylinder 1998 jeep wrangler?
u need to relaese tension on the tension pulley. this is usually done with a long socket wrench handle. when u release tension and remove belt you then release tension on pulley until you have routed new belt . you then move tension pulley again until you can put belt on it, then release pulley and it will automatically provide correct tension
How to Tighten timing belt tensioner for 1994 Camry?
Hiya, Have put new timing belt on 94 Camry 2.2, not a problem, but the tension pulley is not springing back to tighten belt enough, seems odd that the old belt had good tension, have checked and the new belt is the same length, is there a trick to the tension pulley? thanks.
How do you put on a new power steering belt on a 1997 Jeep Grand Cherokee?
Is this a single belt or a serpentine belt system, if so look for belt tension idler pulley and loose belt, or single belt then you will need to loose and release tension on the power steering pump assembly.
Where is the alternator tension bolt 1998fordescort lx?
There isn't one. The tension for the serpentine belt is an automatically spring loaded tensioner on top of the engine in the front. Place a 3/8 inch ratchet in the square slot of the tensioner arm and pull it back to releive tension on the belt. Then when you put the new belt on pull it back to get it on the pullies then release it to tension the belt.
How do you put in a serpentine belt for a 1991 Chevy Astro Van?
Use a socket and ratchet on the 1991 Astro vans serpentine belt tensioner pulley to pull it to the side, letting tension off of the belt. remove the belt and pun the new belt on. Release the tension to hold the new belt on.
Replace belts on 2002 Mitsubishi eclipse?
Put you car on jack stands, remove the right wheel. Loosen the tension pulley for the accessory belt (AC, alternator). Remove the belt. Loosen the tension pulley for the power steering, remove the belt. Install a new belt, and set proper tension. If you do not have a tool to measure tension, use rule of thumb. When the belt is under proper tension you should be able to twist only 3/4 of full twist. Do the same for the accessory belt.
Release the tension on the belt alternator on a 1996 Lincoln mark 8?
You have to use a 1/2 inch breaker bar and put it in the square hole of the tensioner and turn it to release the tension of the belt.
