answersLogoWhite

0

if your 2000 blazer is like my '99 (2 dr) there is no separate rear window washer tank; its at rt frt corner of engine bay.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why wont my 2000 Chevy blazer window roll back up?

Because it hates you!


How do you put a power window of a Chevy blazer back on track?

You will need to remove the inside door panel of your Chevrolet Blazer. Remove the window retaining clips. Put the window back into the window track. Tighten the window retaining clips.


How do you keep the back window from rattling on a 1990 s10 blazer?

new weather stripping.caulkingor new window assembly


How do remove the back seat of a 2000 blazer?

Unbolt it from the floor


Why can't you open the back window of a 2000 Chevy blazer s-10?

The latch on the actuator is probably broken... it's a very common problem for the Blazer. Pull off the trim on the rear door, and you'll be able to see it (and replace it) for yourself.


Where is cam position sensor on a 2000 4.3 liter trail blazer?

it is on the back of the distibutor


How do you remove spare tire from a 2000 Chevy Blazer After inserting key?

I have a Chevy Blazer 2000 4 Wheel Drive ZR2 The Spare Is On The Back With a Lock How do I remove the Spare Tire Thank You


Is there a manual release for the rear window hatch on a 1995 S10 Blazer?

see related link i have a 94 s10 blazer and if you use your key with the back hatch handle you can open it


Where is the thermostst that controls water flow to the heatercore on a 2000 s10 blazer?

no thermonat. there is a cable,behind the glovebox,access inside the back of the glovebox,2 skrews........lol,. no typin skills.


Where is knock sensor located on 2000 s10 Chevy blazer?

left side back of engine by dist.


Where is the washer fluid tank for the back window of a 2001 Chevy Blazer LS?

It uses the same tank that the front windshied uses.


How do you put driver side window back on the track on a 93 Chevy blazer?

Remove the drivers side inside door panel. Remove the retaining clips from the window track. Place the new window in the window track and tighten the retaining clips.