Below are the instructions for programming galant's remote. Alternatively, you can get the instructions from www.programyourremote.com Locate the Data Port under drivers side dashboard usually located to the right of steering column.
Insert keys in ignition and leave in the OFF position.
Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.
Disconnect the programming wire and remove the keys from the ignition..
Check the battery in the remote, if it is still good then get out the owners manual and read up on how to reprogram your remote because it may have unlearned the frequency for your van
It has to be by a dealer.
it must be done at a local Audi dealership
Your keyless remote might not work for your 2002 Chevy Tahoe because the battery in the remote is dead. You can replace this battery by prying the remote cover off of the back of the remote or by removing the screws holding the cover closed.
Go to a mechanic
No.
The dealer scan tool is required to program a remote.
One reason that a keyless entry remote will not open the doors is a dead battery, either on the vehicle or the key itself. Another reason is that the remote needs to be reprogrammed.
Needs remote starter installed
That info MAY be at programyourremote.com (program your remote.com)
That's a dealer item.
You go to the dealership. Take proof of car ownership(registration) and proof of ID (Drivers license) it doesn't cost that much and it can be done there at the dealership in just a few minutes. Answer 2 You may just need to reprogram your keyless keyfob or replace the battery. Follow the link below to reprogram. Hope this helps. "G"