0
How do you reach in to repair and replaced the dashboard blower motor for the fandefroster?
Wiki User
∙ 16y ago
it's under the dash on passenger side secured with 4 screws. disconnect the harness as well before removal.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
The water pump was recently replaced on a 4 door 98 grand am when the car was received back the blower for the heater wasn't working is the water pump repair related to the blower failing?
Probably not.
How do you repair dashboard scratches on a 04 subaru?
Get a new dashboard!
How do you remove the dashboard on a 1996 Ford Fiesta to repair the heater?
How do you remove the dashboard on a 1996 Ford Fiesta
How do you repair blower motor on 98 Eldorado?
If the blower motor is bad then you need to replace it, you don't repair it. The blower is located under the hood and you will need loosen the cradle bolts to rock the engine to remove the blower motor. Book time for this job is 2 hours................
How do you remove the dashboard on a Mercury Grand Marquis dashboard?
The repair section on autozone.com explains how to change the light switch.
How do you repair 2003 Ford Taurus rear catalytic converter?
You can't repair it. It must be replaced.You can't repair it. It must be replaced.
How do you repair the dashboard gauges on a Mercury Cougar?
u dont
How do you repair a noisy blower motor on a 2003 Tundra?
replace it
How do you repair a gas powered leaf blower?
You leaf it alone!
Repair squeaking blower motor 2000 Chevy s10?
No repairing those blower motors, replace it with a new one.
Where can you bring your gas powered leaf blower for repair?
Any small engine/lawnmower repair shop in your area.
Why does heater fan only work on high speed?
Defective ballast resistor pack.OTHER :It sounds like it could be the blower motor relay / resistor. I replaced mine today in my 2001 Chevy Impala. It was next to impossible since I heard that the way to get to the resistor was to remove the blower motor housing and repair it that way. I instead removed the blower motor and got to it that way. The two screws in the back are knuckle busters. Good luck and I hope you have patience or enough money to have someone else repair it.
