Savage Arms and J. Stevens

How do you reassemble a Stevens 311A if the forend came off and can only be replaced with the barrel removed?


Top Answer
User Avatar
Wiki User
2011-09-13 06:08:39
2011-09-13 06:08:39

There should be a lug on the bottom of the barrels and a spring-loaded lever on the top of the forearm. Put the barrels in place on the frame, set the concave metal back of the forearm against the convex part of the frame below the barrels and the lever behind the lug. Then push the forearm and the barrels together. WATCH YOUR FINGERS! It will snap into place.

AnswerThe Forend can only be replaced with the barrels in place and locked.Follow the instructions in the first answer.The foreend can be installed on the barrels when gun is disassembled for storage but would have to be removed to install barrels back onto receiver

Related Questions

If your Stevens is a bolt action, it is NOT a visible loader. If it has any part (perhaps the barrel) that is marked as a visible loader, that part has been replaced.

The Stevens will accept whatever caliber designation is stamped on the side of the barrel.

Yes in 1860 Stevens made a double barrel, all steel barrel and its has external hammers.

A rifle that has barrel removed- not likely. Revolver that has barrel removed- VERY likely.

The Stevens double barrel shotgun is worth $350 to $450 dollars. The value is determined by the gun's mechanical condition.

pull forearm off. open barrel and remove. drift 2 trigger assembly pins out. pull trigger ass. down and out. now drift the barrel catch pin and the lever and catch can be removed.

The Stevens model 311 was discontinued in the year 1989.You would have to contact Savage/Stevens to get the actual age of your double barrel shotgun.

If it is a typical Stevens double or single barrel there should be a metal lever towards the back of the stock slide it left or right and tilt the barrel down.

the value of a 1948 Stevens double barrel shotgun 16 gauge. Hammerless.

the barrel cant be replaced. the barrel is plastic with a steel shell

A replacement barrel for a J. Stevens Arms C20-A shotgun can be found at a local gun/firearms store. If the replacement barrel is not available on site, ask if the store can order it for you.

There was no 'Model A.' In any event, Stevens double-barrel 16ga shotguns in typical condition sell for $200-$250.

It s a Stevens model 311D double barrel shotgun serial number A226687 16 gauge. everything is on the side of the shotgun.

The Stevens 235 was made from 1912 until 1932.

The ignition barrel can be removed by removing the retaining ring. The barrel will slide out. Remove the wiring harness from the back of the barrel.

front trigger fires right barrel. back trigger fires left. boone

the stevans/savage double barrel 503a was made between 1936 and 1954

What year was J stevens made serialk #203j

Stevens 5100 was manufactured from 1931 until 1941

The best that I can do is state that the Stevens model 311 side by side was discontinued in the year 1989.

The patent date you are looking at does not indicate a year of manufacture. Stevens made many different models of double-barrel shotgun. Which model do you have?

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.