0
How do you recognize machining faults and how to identify when tools need re and sharpening?
Wiki User
∙ 6y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are the two types of fault in induction motors?
bearing faults and circuit connection faults
Where is mho relay used?
MHO distance relays are used to protect andÊdetect faults and the location of faults on a transmission line. It detects faults by measuring and comparing phase angles through a phase comparator.
Why short circuit and accidental ground is the most dangerous faults?
These are the most dangerous faults because you will be dealing with very high fault levels. Phase to phase will have very little to limit the impedance of the fault current. And phase to ground faults can be high since most systems are solidly grounded. Arching faults and faults through an impedance will be lower and cause less electrical and mechanical stress on the system.
Is the telltale factor for ascertaining where faults in a cable lie?
Impedance.
3 types of faults?
Reverse faultNormal faultStrike-slip fault
How do electricians use ICT?
Electricians use ICT to identify faults within circuits...................HOPE THIS HELPS HA HA HA
What is magnetic balance test of transformer?
The Magnetic Balance test is conducted on Transformers to identify inter turn faults and magnetic imbalance.
How do you smooth sharp edges of a mirror?
Use fine sandpaper or a sharpening stone, whet stone, to remove the sharp edges being careful not to scratch the reflective backing. This will also strengthen the glass/mirror by reducing faults where breaks can occur.
Are the three types of faults normal faults backward faults and slip faults?
No. Your terminology is close but not quite right. The three main types of faults are normal faults, reverse faults, and strike-slip faults. Strike-slip faults may also be called transform faults.
What kind fault lines are there?
There are 6 types of fault lines. Strike-slip faults, dip-slip faults, oblique- slip faults, listric faults, ring faults, and synthetic and antithetic faults.
How faults are made?
Faults are created when tectonic plates are stretching or compressing. There are two types of faults which are normal and reverse faults.
Two types of faults can result in mountains which are they?
The two types of faults that can result in mountains are reverse faults and normal faults.
How are earths faults different from your faults?
Your faults are flaws in your personality. Earth's faults are cracks in the ground along which blocks of rock move.
How are earth's faults different from your faults?
Your faults are flaws in your personality. Earth's faults are cracks in the ground along which blocks of rock move.
How are are earths faults different from your faults?
Your faults are flaws in your personality. Earth's faults are cracks in the ground along which blocks of rock move.
What is the main direction of stress on blocks of rock at normql faults reverse faults and strike-slip faults?
The main direction of the stress on blocks of rock at normal faults, reverse faults and the strike slip faults usually happens at the weak areas.
What are the faults in the cable?
Cable faults are normally categorised as (a) conductor-to-earth (ground) faults, (b) conductor-to-conductor faults, and (c) conductor-to-conductor-to earth (ground) faults. In addition to that, we can categorise them by whether they are 'high-resistance' or 'low-resistance' faults.
