Want this question answered?
To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
The front fork tubes in a 1996 Suzuki Intruder VS 800 are 40mm.
What colors are the front signal light wires
125 front main 140 rear main
The engine number, on your Suzuki 1500 motorcycle, is located on the front of the engine block. The engine number is cut into the block.
under left side cover. you will see the battery cable connected to it. on the front side.
ON THE VS 800 AND VS 1400 THE BATTERY IS IN FRONT OF REAR WHEEL UNDER THE BIKE ON THE VL 1500 TI IS IN THE FRONT ON THE BOTTOM
Battery is under seat. Remove rear seat first with an Allen wrench then using same wrench remove front seat use Phillips screw driver or 10mm wrench or socket to remove cables from battery. Reverse these directions for installation and assembly.
break it off.
it is in the cver right in front of the tool compartment where the shift rod hooks up to ngine it is right in front of it has two screws holding it in and has one wire going to it
The tool kit on my 2001 Suzuki 800 Intruder is located behind the backrest cushion, its a hard plastic compartment behind the cushion .... gently pry or pull off the backrest. The cushion it pulls straight off towards the front. It has a keyed lock, remove cover revealing a pouch of tools. Hope this helps
It is beside your cylinder. if you take your cylinder heads off you'll see a spring and the cam chain looped around it