Begin by removing the engine wiring harnesses. Remove the motor mount retaining bolts. Disconnect the engine from the transmission. Lift the engine out.
The engine oil drain plug is located at the lowest point of the engine oil pan. It should take a 15mm wrench to remove it.
No. You can remove the engine and leave the transmission in the vehicle.
The transmission dipstick on a 1998 Blazer should be located at the rear of the engine. It should not be near the oil dipstick.
is it factory or an add on?
Unbolt it.
1998 chevy blazer wont start good spark and good fuel presure
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
Assuming you mean the engine oil drain, it is located at the lowest point on the oil pan and requires a 15mm wrench to remove it.
No. just remove the plastic piece around the radio. It pops off.
When you overhaul the engine. It is designed to last the life of the engine.
how to remove the starter from a 92 s-10 4x2 with a 2.8 engine
With great difficulty.