The diagnostic link is behind the ashtray,which you will have to remove to get to the connector.
Removal and Installation Remove the trim panel. Release the clip. Release the locating tabs. Remove the trim panel. Disconnect the exterior mirror control switch electrical connector. Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the electrical connector. Remove the exterior mirror. Remove the bolt. If equipped, remove the screw. To install, reverse the removal procedure.
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
Remove the electrical connector from the old resistor. Remove the screws holding the resistor in place. Remove the old resistor. Put in the new one and screw in the screws. Attach the electrical connector.
Door Speakers: * Remove the door trim panel * Remove the speaker mounting screws * Pull out the speaker and disconnect the electrical connector from the speaker and remove the speaker Door Subwoofers: * Remove the subwoofer grille trim panel * Remove the door trim panel * Remove the 8 mounting screws from the front side of the subwoofer * Remove the single subwoofer retaining screw from the backside of the subwoofer enclosure * Pull out the subwoofer,disconnect the electrical connector and remove the subwoofer Quarter Panel Speakers: * Remove the quarter panel trim * Remove the 4 speaker mounting screws * Pull out the speaker,disconnect the electrical connector and remove the speaker Parcel Shelf Speakers: * Working from inside the trunk area,disconnect the speaker electrical connector * Remove the parcel shelf * Remove the speaker mounting screws and remove the speaker
is located under the ashtray behind the shifter ,remove piece of plastic and the obd ll connector is there
You do not need to remove the console to change the lighter connector. Twist the lighter base counter clockwise and it will pop out. Unplug it from the electrical connector and replace it.
If it is a front bulb, sometimes you can get to the bulb and remove it by turning it counterclockwise. If it is the rear you have to remove the housing and then remove the bulb. Remove the (4) 7mm Hex screws that fasten the wheel well liner. Pull the liner back as needed. Then reach in and remove the bulb by twisting the connector to release the connector and bulb from the turn signal housing. Pull the connector back towards you and replace the bulb.
Remove the front bumper fascia.Unplug the horn electrical connector and remove the bracket bolt.
Remove a battery connector. Remove the starter and put another in it's place.
You can remove the headlight by removing the retaining screws. Remove the headlight wiring. The headlight should easily come out.
Take hold of the turn signal light connector. Push the connector in and turn at the same time. The connector and light will come free. Do the same with the light bulb to remove it.