To remove the supercharger pulley from a Toyota Previa, first, ensure the engine is cool and disconnect the battery. Next, remove the supercharger assembly, which may involve detaching the intake manifold and other components. Use a pulley puller tool to carefully extract the pulley from the supercharger shaft. Finally, inspect the pulley and surrounding components for wear or damage before reassembly.
To change the supercharger oil in a 1995 Toyota Previa, first, ensure the engine is cool and disconnect the battery. Remove the supercharger from the vehicle, then locate the oil fill and drain plug on the supercharger. Drain the old oil, replace it with fresh supercharger oil (usually a specific type like Toyota SC oil), and reassemble everything, ensuring all seals are tight. Finally, reconnect the battery and test the supercharger to ensure proper operation.
Go to www.zzperformance.com and you will be able to rent a pulley puller do not use a regular pulley puller they. It is about 30 bucks to rent. It will take about an hour to do
You will need to remove the front engine cover, on your 1997 Pontiac Bonneville, in order to change the supercharger belt. Loosen the tensioner pulley to remove the belt.
To disable the supercharger on a 2004 Pontiac Grand Prix, you can remove the supercharger belt from the supercharger pulley. This involves locating the tensioner pulley, releasing the tension, and sliding the belt off. Additionally, you can disconnect the supercharger's electrical connector to prevent it from engaging. Keep in mind that doing this may affect the vehicle's performance and is generally not recommended unless for maintenance or repair purposes.
remove the radiator, then remove 4 screws that holds the fan ,,done..
yes, you have. And change new seal too.
I would advise you to check out the Previa site on yahoo. It is an excellent site. Check this site it out http://tarago.blogspot.com/ , it helped a lot.
To remove the pulley belt tensioner from a 1995 Oldsmobile 98 Supercharger, first, disconnect the battery and relieve any tension on the serpentine belt by using a wrench on the tensioner pulley. Next, carefully remove the belt from the tensioner pulley. Once the belt is off, unbolt the tensioner from its mounting bracket, typically using a socket or wrench. Finally, lift the tensioner off the engine to complete the removal.
remove the radio.and once outside remove the tape deck wich is screw to te radio.
Get a Haynes manual - there's a lot of stuff to take off
look in how to bleed air off cooling system
You have to get a pulley puller of the appropriate size. Without a pulley you have no chance safely to remove it. Be careful do not deform the pulley it's not that hard as you can think.