0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Diagram of a coil for a Ford Laser 1991?
A 1991 ford laser has an electronic ignition and it should be located on the rigt side of the engine bay. It is an 'A' shaped thing with a cable going to the distributor and black and white plugs underneath. Hope this helps.
How do you remove ignition tumbler 1998 Ford Mustang?
How do you remove ignition tumbler 1998 ford Mustang?
How do you replace ignition module on 1991 ford f-150?
Look on the side of your distributor. It takes a special wrench to remove it if it is there.
How do you remove ignition switch from 1992 Ford Explorer?
Type your answer here... How do you remove ignition switch from 1992 ford explorer?
Where is the dura spark ignition module located on a 1991 Ford probe?
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Remove ignition core from 1995 ford e150 van?
Remove the ignition retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition.
How do you remove the ignition module on a 1988 ford f-250?
how do you remove the ignition control module on a 1988 ford f-250 pickup?
Can I get an ignition key made for a 1991 Ford Escort made at a Ford dealership?
Henry ford
Where can you find the engine number of Ford Laser 1.6 1991?
Hey, I have a 1991 kf laser 1.6L and it is a 'B6-2E' engine and the number is on the block.
How do remove the ignition switch in the Ford Aspire?
You Dont.
How do you remove a frozen ignition lock from a 1991 ford ranger It will not turn at all so the release pin cannot be pushed?
drill through the release pin
How do you remove the ignition barrel on an 87 Ford Laser?
Remove the steering column surround and you should see a black round thing on the left hand side, this is the ignition switch. Remove this and you will see there is one screw holding the ignition barrel on, remove and you then need to insert your key and turn it to the ACC position. you should now be able to withdraw the barrel using the key but take care not to snap the key off in the barrel
